User Manual Part 2

Analog Color Bar Generator B-7MTX5000 User and Technical Manual
Figure B-5: Main Screen - Typical
CAUTION
Always wait a minimum of 5 seconds after
the Main screen is displayed following
power up before selecting a Preset.
Note
In order to set up the analog CBG, an analog
Preset must be selected in the following step. Any
analog Preset may be selected.
12. Select any analog Preset per “Select Preset” on
page 3-24.
Note
When performing steps at the MTX5000 IDU in the
following steps, option buttons may be selected
using either the touch screen or the function keys
and the SEL key.
13. Observe the Main screen is displayed. See Figure B-
6.
Channel 1 0Offset
Antenna Ant. Pol.Antenna1 H
RFU1
No RF
RF Band
Preset A
Analog
4.83 & 5.8, 3MHz Vid Dev
RF Output
XX
dBm
<- Status
Setup
Status ->
PA Off
SUM
ODU
IDU
RF
L/R
L
L
Figure B-6: Main Screen - Typical
14. Select the Setup option button and observe the Setup
screen is displayed. See Figure B-7.
Figure B-7: Setup Screen
15. Select the Radio option button and observe the Radio
screen is displayed. See Figure B-8 on page B-8.
Channel 1 0Offset
Antenna Ant. Pol.Antenna1 H
RFU1
No RF
RF Band
Preset A
Analog
4.83 & 5.8, 3MHz Vid Dev
RF Output
XX
dBm
<- Status
Setup
Status ->
PA Off
SUM
ODU
IDU
RF
L/R
L
L
Setup
User
Main
Radio