User Manual Part 2

Analog Color Bar Generator B-5MTX5000 User and Technical Manual
WARNING
Remove all jewelry before beginning work
on the equipment.
Jewelry can conduct electrical current.
Accidental contact can result in
electrocution or severe burns.
WARNING
Rotating equipment (cooling fans) is used in
the operation of this equipment.
When performing this procedure, know the
location of the rotating equipment.
WARNING
Remove all jewelry before beginning work
on the equipment.
Jewelry can be caught in rotating equipment
or on protruding parts, resulting in injury.
CAUTION
Electrostatic Discharge (ESD)
The MTX5000 IDU and the CBG contain
components that are sensitive to
electrostatic discharge. Observe static
precautions when configuring the CBG.
Perform all work on a static free work
surface. Use a conductive mat that is
properly grounded or ensure the MTX5000
IDU is electrically connected to earth
ground.
Use a grounded wrist strap, and ensure the
strap makes good skin contact. The wrist
strap must be electrically grounded to the
bench or MTX5000 IDU chassis at all times.
1. If you have not already done so, perform the following:
- Power down the MTX5000 System. See ”Powering
the MTX5000 System” on page 3-7.
- Disconnect all cables and remove the MTX5000 IDU
from its rack (if already mounted).
2. Remove 8 screws from the top of the unit, remove 2
screws at the rear of the unit, and remove the
MTX5000 IDU cover panel.
3. Position the MTX5000 IDU with its front panel to your
left. This will orient the four control switches, as
shown in Figure B-3 on page B-6.