User Manual Part 2

Installation 6-28MTX5000 User and Technical Manual
The procedure required to apply power to the MTX5000 system
is contained in the following steps.
1. Verify the power cable is properly connected to the
MTX5000 IDU rear panel POWER IN AC power
connector.
2. Verify all coaxial cables and cable connectors are
properly connected to the rear panel connectors and
verify the ODU is properly connected.
3. Verify the MTX5000 power cable is connected to AC
power of the correct type and voltage.
4. Verify the AC power source is turned on.
5. Raise the power switch protective switch cover, press
the power switch, observe the symbol on the switch
illuminates green, and close the protective switch
cover.
Note
When power is applied to the MTX5000, it will
automatically enter the local normal user mode of
operation.
The MTX5000 will return to the last settings that
were in use when the unit was powered down, but
the MTX5000 will not resume transmitting if the unit
was transmitting when it was powered down.
If the MTX5000 was in the remote mode when
power was removed, the IDU will not return to the
remote mode.
6. The normal power-up sequence is as follows:
- After a short delay (approximately 30 seconds), the
introduction screen will be displayed on the color LCD
display panel. See Figure 6-18.
- After another short delay (approximately 30 seconds),
the Main screen will be displayed on the color LCD
display panel. See Figure 6-19.
Figure 6-18: Introduction Screen
Figure 6-19: Main Screen - Typical
7. If everything appears to be normal, test the
performance of your MTX5000 by setting up a link and
transmitting video and audio.
- If you have any problems, refer to the
“Troubleshooting” Chapter on page 4-1.
Channel 1 0Offset
Antenna Ant. Pol.Antenna1 H
RFU1
No RF
RF Band
Preset A
Analog
4.83 & 5.8, 3MHz Vid Dev
RF Output
XX
dBm
<- Status
Setup
Status ->
PA Off
SUM
ODU
IDU
RF
L/R
L
L