User Manual Part 2

Installation 6-14MTX5000 User and Technical Manual
If you are installing the RFU in a different configuration, consult
the installation instructions that came with your hardware.
When you have installed the RFU, go to “Making the
Connections” on page 6-15.
6.11.1 Site Preparation
Each installation will be different. In general, MRC recommends
the following sequence:
• Install the mast.
• Lower the fabricated wiring harness over the mast.
• Mount the Pan & Tilt to the mast.
• Mount the RFU(s) to the Pan & Tilt. See ”Mounting the
ODU” .
• Mount the antenna to the Pan & Tilt.
6.11.2 Mounting the ODU
The following instructions describe mounting one ODU (RFU).
To mount a second ODU, repeat the steps.
1. Attach the Mounting Plate to the Pan & Tilt Assembly.
- Align the Mounting Plate to the Pan & Tilt mount as
shown in Figure 6-8.
- Attach the Mounting Plate to the Pan & Tilt mount
using #10-32 screws, lock washers, and flat washers
supplied. See Figure 6-9.
2. Attach the ODU to the Mounting Plate.
Figure 6-8: Alignment of Mounting Plate to Pan and Tilt
Figure 6-9: Mounting Plate Attachment to Pan and Tilt
Pan and Tilt Assembly
Mounting Plate
MOUNTING
PLATE
PAN & TILT
MOUNT
#10 SCREW
#10 LOCKWASHER
#10 FLAT WASHER