User Manual Part 1

Routine Operation 3-58MTX5000 User and Technical Manual
Figure 3-122: Radio Screen
4. Select the System Info option button and observe the
System Info screen is displayed. See Figure 3-123.
Figure 3-123: System Info Screen - Typical
5. When review of the System Info screen is complete,
select the Back option button and observe the Radio
screen is displayed.
6. Select the Main option button and observe the Main
screen is displayed.
Radio
Back
Network Config Level Adjust Color Bars
Calibration
Time & Date
Change Pwd
System Info
License Key
Diagnostics
Next
Main
System Info
Back
MTX5000 Control Software V.00.04.XX
Serial #: XXXXX_XX
Date of Manufacture: 03.17.09
System Type Type 11
2.0.0 Analog Software 2.0.1
SCM Software 3.0.1
MPEG Software
3.6.19 Set Last PA State
The IDU can be configured to return the PA to the last operating
state (PA Off, PA On, or always PA Off) when the unit is
powered down and is then powered up again. After powering
down, the next time the IDU is powered up, the PA will return to
the state selected. The procedure required to set the last PA
state is contained in the following steps.
Note
In the following procedure, option buttons may be
selected using either the touch screen or the
function keys and the SEL key.
1. Observe the Main screen is displayed. See Figure 3-
124.
Figure 3-124: Main Screen - Typical
2. Select the Setup option button and observe the Setup
screen is displayed. See Figure 3-125 on page 3-59.
Channel 1 0Offset
Antenna Ant. Pol.Antenna1 H
RFU2
7US
RF Band
Preset A
Analog
4.83 & 5.8, 3MHz Vid Dev
RF Output
XX
dBm
<- Status
Setup
Status ->
PA On
SUM
ODU
IDU
RF
L/R
H
L
Setup Option
Button