User Manual Part 1

Routine Operation 3-49MTX5000 User and Technical Manual
Figure 3-99: Calibration Successful
11. Select the Previous option button and observe the
Radio screen is displayed. See Figure 3-100.
Figure 3-100: Radio Screen
12. Select the Main option button and observe the Main
screen is displayed.
3.6.14 Perform RF Level Adjust
The procedure required to adjust the RF output level when
operating in the digital mode is contained in the following steps.
Start
Calibration Successful
<-Previous Next->
Main
Radio
Back
Network Config Level Adjust Color Bars
Calibration
Time & Date
Change Pwd
System Info
License Key
Diagnostics
NextMain
This procedure provides the means to adjust the RF level output
manually (not recommended), if required. This procedure also
provides the steps to select the Auto mode (recommended).
CAUTION
It is highly recommended that the RF output
level be set to the Auto mode for optimum
performance.
Manually setting the RF output level runs
the risk of exceeding the FCC mask or of
deteriorating digital performance.
Notes
The RF output level can only be adjusted if you are
operating in the digital mode with a digital Preset
selected.
The RF output level cannot be adjusted if you are
operating in the analog mode.
Note
In the following procedure, option buttons may be
selected using either the touch screen or the
function keys and the SEL key.
1. Observe the Main screen is displayed. See Figure 3-
101 on page 3-50.