User Manual Part 1

Routine Operation 3-34MTX5000 User and Technical Manual
2. Select the Antenna option button and observe the
Antenna screen is displayed.
See Figure 3-57.
Figure 3-57: Antenna Screen - Typical
3. Select the Antenna option button required, select the
Main option button, observe the Main screen is
displayed, and observe the antenna selected is
displayed. See Figure 3-58.
Figure 3-58: Main Screen - Typical
3.6.6 Select Antenna Polarization
The procedure required to select the antenna polarization is
contained in the following steps.
Antenna
Option
Buttons
Antenna
Main PA On
SUM
ODU
IDU
RF
L/R
H
Ant. 1
Ant. 2
Antenna1
Antenna2
L
Channel 2 0Offset
Antenna Ant. Pol.Antenna2 V
RFU2
7US
RF Band
Preset A
Analog
4.83 & 5.8, 3MHz Vid Dev
RF Output
XX
dBm
<- Status
Setup
Status ->
PA On
SUM
ODU
IDU
RF
L/R
H
L
New
Antenna
Setting
When performing the following steps, a navigation option button
to return you to the Main screen will be displayed at the bottom
of the Antenna Polarity screen.
When the new antenna polarization is selected, the Main option
button must be selected, the Main screen will be displayed, and
the updated system status associated with the Ant. Pol. option
button will display the new selected antenna polarization. The
options available are H (Horizontal), V (Vertical), RC (Right
Circular), and LC (Left Circular).
If the Main option button is selected to return to the Main screen
without selecting a new antenna polarization setting, the Main
screen will be displayed and no changes will be made to current
MTX5000 settings.
Note
In the following steps, option buttons may be
selected using either the touch screen or the
function keys and the SEL key.
1. Observe the Main screen is displayed. See Figure 3-
59.
Figure 3-59: Main Screen - Typical
Channel 1 0Offset
Antenna Ant. Pol.Antenna1 V
RFU2
7US
RF Band
Preset A
Analog
4.83 & 5.8, 3MHz Vid Dev
RF Output
XX
dBm
<- Status Setup
Status ->
PA On
SUM
ODU
IDU
RF
L/R
H
L
Ant.Pol.
Option
Button