User Manual Part 1

Routine Operation 3-30MTX5000 User and Technical Manual
4. After a short delay, observe the new RF Band is active
(blue), select the Main option button, and observe the
new RF band setting is displayed.
See Figure 3-46.
Figure 3-46: Main Screen - Typical
5. To select a new operating channel, perform “Select/
Customize Operating Channels”, as required.
3.6.3 Select/Customize Operating Channels
The procedure required to select an operating channel or to
prepare a customized channel is contained in the following
steps.
When performing the following steps, a navigation option button
to return you to the Main screen will be displayed at the bottom
of the Channel screen.
When the new channel options are selected, the Main screen will
be displayed and the updated system status associated with the
Channel option button will display the newly selected channel.
When a channel is customized, the channel number that was
changed will not automatically be displayed on the Main page
unless that channel was already selected. If a channel is
Channel 1 0Offset
Antenna Ant. Pol.Antenna1 V
RFU1
2G17M
RF Band
Preset A
Analog
4.83 & 5.8, 3MHz Vid Dev
RF Output
XX
dBm
<- Status
Setup
Status ->
PA On
SUM
ODU
IDU
RF
L/R
H
L
New RF
Band
Setting
customized that was not selected on the Main page, the
customized channel number must be selected from the Main
page using the Channel option button and the Channel screen.
If the Main option button is selected to return to the Main screen
without selecting a new channel, the Main screen will be
displayed and no changes will be made to current MTX5000
settings.
Note
In the following steps, option buttons may be
selected using either the touch screen or the
function keys and the SEL key.
Note
To select the operating channel only, perform step
1 thru step 3.
To customize individual channels, go to step 4.
1. Observe the Main screen is displayed. See Figure 3-
47.
Figure 3-47: Main Screen - Typical
Channel 1 0Offset
Antenna Ant. Pol.Antenna1 V
RFU2
7US
RF Band
Preset A
Analog
4.83 & 5.8, 3MHz Vid Dev
RF Output
XX
dBm
<- Status Setup Status ->
PA On
SUM
ODU
IDU
RF
L/R
H
L
Channel
Option
Button