User Manual Part 1

Routine Operation 3-27MTX5000 User and Technical Manual
Note
If you decide not to select a different Preset in the
following step and select the Main option button
instead, no configuration changes will be made,
the RECONFIGURING RADIO screen will not be
displayed, the Main screen will be displayed, and
no changes will be displayed in the Preset
description box.
9. Use the Previous and Next option buttons, as
required, select the required Preset option button, and
observe the RECONFIGURING RADIO screen is
displayed. See Figure 3-38.
Figure 3-38: RECONFIGURING RADIO Screen - Typical
10. After a short delay, observe the Main screen is
displayed and observe the new Preset and status data
applicable to the Preset is displayed. See Figure 3-39.
60 %
RECONFIGURING RADIO. PLEASE WAIT!
DO NOT POWER OFF RADIO UNTIL RECONFIGURED!
Figure 3-39: Main Screen - Typical
11. Select the PA operation button to resume transmitting,
as required.
3.6.2 Select RF Band
The procedure required to select an RF band ODU is contained
in the following steps.
If your MTX5000 system is a dual band configuration containing
both a 2 GHz and a 7 GHz ODU (RF head), the procedure
required to select the RF head required for either 2 GHz or
7 GHz operation is contained in the following steps. This
procedure is also used to select either the 2 GHz, 17 MHz
channel plan or the 2 GHz, 12 MHz channel plan, as required for
2 GHz operation.
In a dual band configuration, the 2 GHz RF head is typically
connected to the IDU RFU 1 rear panel connector and the 7 GHz
RF head is typically connected to the RFU 2 rear panel
connector. The RF heads may, however, be connected to either
Channel 1 0Offset
Antenna Ant. Pol.Antenna1 H
RFU2
7US
RF Band
Preset E
Digital - COFDM QPSK,
8, 3/4, 1/8, ASI
RF Output
XX
dBm
<- Status
Setup
Status ->
PA Off
SUM
ODU
IDU
RF
L/R
L
L
Preset
Option
Button
Preset Description
Text Box