User Manual Part 1

Routine Operation 3-21MTX5000 User and Technical Manual
Note
Remote operations must performed using
Internet Explorer 7.0 or later.
The procedure required to select the local or remote operation
mode is contained in the following steps. In order to operate the
MTX5000 remotely, you must connect the MTX5000 to a PC via
your web browser.
In order to operate the MTX5000 via remote control using the
optional Remote Access Subnotebook PC, refer the Remote
Access Subnotebook PC Operator’s Guide, part no. 400573-1.
Selection of the local/remote operation modes can only be
performed at the MTX5000.
Note
When performing steps at the MTX5000 in the
following steps, option buttons may be selected
using either the touch screen or the function keys
and the SEL key.
1. Observe the Main screen is displayed. See Figure 3-
25.
Figure 3-25: Main Screen - Typical
Channel 1 0Offset
Antenna Ant. Pol.Antenna1 V
RFU2
7US
RF Band
Preset A
Analog
4.83 & 5.8, 3MHz Vid Dev
RF Output
XX
dBm
<- Status Setup Status ->
PA On
SUM
ODU
IDU
RF
L/R
H
L
Local/
Remote
(L/R)
Option
Button
Note
To select the local operation mode when the
MTX5000 is in the remote mode, perform step 2
and step 3.
To select the remote operation mode when the
MTX5000 is in the local mode and you do not know
the MTX5000 IP address, go to step 4. If you know
the IP address, go to step 9.
2. Observe the L/R option button label indicates R.
3. Select the L/R option button and observe the L/R
option button label changes to L. Procedure is
complete.
4. Select the Setup option button and observe the Setup
screen is displayed.
5. Select the Radio option button and observe the Radio
screen is displayed.
6. Select the Network Config option button and observe
the Network Config screen is displayed.
7. Select the Radio option button and observe the Radio
screen is displayed.
8. Record the IP Address, select the Main option button,
and observe the Main screen is displayed.
Note
In the following step, XX.X.X.XXX is the IP address
of your MTX5000 IDU.
9. At the remote PC, open your web browser, enter the IP
address for your MTX5000, and press the PC
keyboard Enter key. The IP address should be
entered as follows: