User Manual Part 1

Routine Operation 3-18MTX5000 User and Technical Manual
When the Network Config screen Radio Network option button
is selected, the Radio Network screen is displayed.
See
Figure 3-18.
Figure 3-18: Radio Network Screen - Typical
Selection of the Radio IP, Subnet Mask, Gateway, and DNS
Server option buttons allows you to change the network
addresses required to operate your MTX5000 System from a
remote location. Any changes to your network addresses
must be coordinated with your Network Administrator.
Calibration Option Button When the Setup screen
Calibration option button is selected, the PA Voltage Adjust
Setup screen will be displayed. See Figure 3-19.
The PA Voltage Adjust Setup screen provides you with the ability
to calibrate the PA DC power for individual ODUs (RF Units), as
applicable to the options contained in your MTX5000 system, by
selecting the Start option button. The Factory option button is
password-protected for factory use only.
Radio Network IP Address
Back
10.4.3.213
Subnet Mask
Gateway
DNS Server
255.255.0.0
10.4.1.1
10.4.1.21
Main
Figure 3-19: PA Voltage Adjust Setup Screen
Time & Date Option Button When the Date & Time option
button is selected, the Time/Date screen is displayed. See
Figure 3-20. This screen allows you to set the current time and
date.
Figure 3-20: Date & Time Screen - Typical
Level Adjust Option Button When the Setup screen Level
Adjust option button is selected, the RF Output Level Adjust
screen will be displayed. See Figure 3-21 on page 3-19.
<-Previous
Start
Factory->
This process will allow you to calibrate
the PA DC voltage for each specific
frequency band. Once you have the
Radio connected to the ODU
and are ready to start calibration,
Press the START Button below
Main
Time / Date
Submit
Cancel
Date
Time Hour
Year
8
2009
Min.
Month
30
3
Sec.
Day
30
17
Tue – Mar 17, 2009 – 08:30:30
Main