User Manual Part 1

Routine Operation 3-70MTX5000 User and Technical Manual
3. Select the Main tab Channel pull-down menu and
select the Channel pull-down menu option required.
3.8.4 Select Antenna
The procedure required to select the operating antenna is
contained in the following steps. When the Antenna pull-down
menu option is selected, the Antenna pull-down menu will
display the selected antenna.
1. Verify the MTX5000 system is powered up and the
system is in the remote operating mode.
2. Observe the Remote screen is displayed on the
remote PC display. See Figure 3-144.
Figure 3-144: Remote Screen Display - Typical
3. Select the Main tab Antenna pull-down menu and
select the Antenna pull-down menu option required.
3.8.5 Select Frequency Offset
The procedure required to select the operating channel offset is
contained in the following steps. When the Offset pull-down
menu is selected, the Offset pull-down menu will display the
selected channel offset.
1. Verify the MTX5000 system is powered up and the
system is in the remote operating mode.
2. Observe the Remote screen is displayed on the
remote PC display. See Figure 3-145.
Figure 3-145: Remote Screen Display - Typical
3. Select the Main tab Offset pull-down menu and select
the Offset menu option required.
3.8.6 Select Antenna Polarization
The procedure required to select antenna polarization is
contained in the following steps. When the new antenna
polarization is selected, the updated Antenna Polarity pull-
down menu will display the selected antenna.
1. Verify the MTX5000 system is powered up and the
system is in the remote operating mode.