User Manual Part 1

Routine Operation 3-68MTX5000 User and Technical Manual
Figure 3-140: Remote Screen Display - Typical
3. Select the Main tab Preset pull-down menu (Figure 3-
141) and select the Preset required.
Figure 3-141: CONFIGURATION - Preset Pull-Down Menu -
Typical
CAUTION
It may take approximately 30 seconds to
change Presets from the remote location.
Do not become impatient during the
configuration process in the following
steps. If you do not allow processing to
complete, software corruption will occur!
4. Observe the Reconfiguring Radio. Please Wait...
window is displayed until the MTX5000 has been re-
configured.
5. Observe the parameters for the selected Preset are
displayed in the Status tab Analog, Digital, and/or IP
tabs, as applicable.
6. Select the Main tab PA Control pull-down menu On
option to resume transmitting, as required.
3.8.2 Select RF Band and Channel Plan
The procedure required to select an RF band (RFU) and a
channel plan from a remote location is contained in the following
steps.
If your MTX5000 system is a dual band configuration, the
procedure required to select the RFU required for dual band
operation is contained in the following steps. This procedure is
also used to select the channel plan required for operation.
In a typical 2 GHz and 7 GHz dual band configuration, the 2 GHz
RF head is typically connected to the IDU RFU 1 rear panel
connector and the 7 GHz RF head is typically connected to the
RFU 2 rear panel connector. The RF heads may, however, be
connected to either rear panel connector. The MTX5000
software automatically detects the RF heads and assigns RFU1