User's Manual

Page 35
NewStream User Guide and Technical Manual
NOTE: If you are placing the LGR behind a router/fi rewall, you will need to forward at a
minimum, port 4001 TCP/UDP to the LGR. You can change the LGR’s listening port on
the Setup > LGR Inputs Web page. If you do change the port, be sure to change the port
on
NewS
tream as well.
5. On the LiveGear Receiver:
a. Using the touchscreen on the front panel, press the up arrow to display the WAN
IP address. This IP address needs to be entered in the Destination Stream
address fi eld using the NewStream Web page [see confi guration steps below].
b. Default Listening Ports are: 4001 for Channel 1 or 4002 for Channel 2.
c. Save the settings
d. Select the Status button to return to the Status screen.
6. Apply power to
NewStream using power rocker switch on front panel. Wait for the
initialization process to complete [approximately 45 seconds]. Allow approximately one
minute for NewStream to boot up and optimize the cellular links for broadcast.
7. On the NewStream IDU - fi rst connect an Ethernet cable to an Ethernet port:
a. Check that the Cellular Status screen shows service for the cell modems with
SIM cards installed [refer below to Figure 31 (and Figure 21 in Local mode)].
Power cycle the IDU if the cellular carriers do not connect.
b. Once NewStream is booted and the modems are connected, select Remote
Control mode and open the Web interface and select Setup > Modify Presets. Select
the Copy Preset option
on the default CNG Preset if you have not yet confi gured
any CNG Presets to begin confi guration. Refer to Remote Operation Using the Web
Interface, in this manual for more information about NewStream Remote control.
c. Name the new CNG Preset, click the Create Preset button and fi nally click the
Save Preset icon
. It is important to note that if you modify the preset name
or type, be sure to click the Save Preset icon before customizing additional settings.
d. Use the Edit Preset icon to customize the newly created preset. Select the
Cellular Settings using the
icon and chose the Cell Mode Delay that most closely
matches the type of video that you plan to transmit.
e. Ensure that the Destination Stream IP address is set to the LGR’s IP address to
which you will stream the video feed.
f. Select a Port Number [#] to set the listening port to stream the video feed.
g. Select a Channel number to set the LGR Channel to stream the video feed.
h. Adjust the Encoder controls based on the carrier service available.
i. Set the Cellular Transport Stream using the entry fi elds provided.
j. Set the Audio Encoding and Input based on the carrier service available.
k. Select the Save button to return to the Modify Presets Web page.
l. Ensure that you have a secure connection to your video source at the Video
Input BNC connector on the rear panel of the NewStream transmitter.
m. Press NewStream’s Start or Stop Cellular Transmission button to begin live
streaming [see Figure 5 item O].
8. You can view connection status by logging into the LGR Web interface and selecting
Channel 1 on the drop-down menu.