User's Manual

Page 33

NewStream User Guide and Technical Manual

Conﬁ guration Mode

The Conﬁ guration Mode touchscreen displays the current operational state of the

NewStream system. The Local/Remote control button allows you to toggle between the

two states.

• Local mode – operation and control of the transmitter is done solely from the IDU

front panel and read only access is allowed to NewStream via the Web interface.

• Remote mode – operation and control of the system can be executed from the

Web interface. The IDU front panel buttons are inactive but the displays, screens

and buttons show current states. The Local button changes color and Remote

appears when the toggle is activated [see example].

NOTE:

Setting the unit in Local or Remote mode is done at the IDU by the operator

and must remain in this mode each time the unit is started. When NewStream is in

Local mode the IDU will not accept any remote commands however, remote access

is allowed for status monitoring.

The touchscreen also allows you to view the current Antenna [1 or 2 in ENG mode

only] and Audio Alignment conﬁ guration. There are two Audio Alignment options:

EBU or SMPTE. For more information, refer to NewStream Settings under Remote

control in the General Settings section. There is also a Brightness control for

the overall appearance of the screens. Tap the button to the right to brighten the

touchscreen display.

Cellular [CNG] Operation

This section describes the operation of the IDU in local and remote control using the

touchscreen and the button/LEDs associated with the front panel Cellular portion, as

well as the Web interface.

Figure 20: NewStream Local/Remote Selection Touchscreen