User Manual

1-7HDT-1000S2 User and Technical
Rev 1
Membrane Switch Control Features
5.1 Selecting a Preset
The HDT-1000S2 recalls the most recently saved preset when it is powered up. To select a
preset, do the following:
1. Press the PRESET key. The currently selected preset LED flashes.
2. Press the up and down arrows to choose the new preset you want.
3. Press the SAVE key. The preset LED flashes to indicate the preset was chosen and the
LED is illuminated to indicate the operational preset.
If the SAVE key is not pressed within 5 seconds, the preset returns to the most recently used
value and the selection mode is canceled.
PRESET LED Displays the selected preset (1-16).
RF HI/LOW Toggle between high and low power output.
Up arrow Move up through presets.
AUDIO 1
MIC/LINE
Press to set Audio 1to Mic or Line and press SAVE to set.
Audio LEDs Green when enabled; otherwise dark. M=MIC; L=LINE
RF HI LED Green when the radio power output is high; dark when low.
SAVE Sets new preset.
VID LED Green when a valid NTSC or PAL analog composite video signal, as well as an
ASI, or HD-SDI digital video signal is present; otherwise dark
ALARM LED Red when an alarm occurs; otherwise dark.
CRYPTO LED Green when encryption is enabled and the transmitter is transmitting the
encryption code associated with the preset; dark when disabled.
AUDIO 2
MIC/LINE
Press to set Audio 2 to Mic or Line and press SAVE to set.
Down arrow Move down through presets.
PRESET key Press to select one of the stored presets (1-16). The PRESET LED indicates
the current preset. Use the up or down arrow to select a new preset. Press
SAVE to select the new setting.
Multi-LED display Indicates which preset is being used. The LEDs remain lit until another option
button is selected or until the dark timer elapses.