User Manual

1-14
HDT-1000S2 User and Technical
Rev 1
8.3 ETHERNET Connector
The following table shows the pin-out information for the RJ-45 network ethernet connector,
which lets you connect the receiver to a computer and use the receiver’s web browser interface
to control the receiver; also used for the IP streaming data output from the unit.
8.4 DATA Connector
I/O connector 21-Pin Male D connector pin-outs are shown in the following table:
8.5 DC Power Connection
The following table shows the pin-outs for the Lemo (FGGOB304CLAD52) POWER IN 4-pin
male power
connector. Vislink supplies a DC power cable assembly with each unit.
Connector Pinout Signal Description Pinout Signal Description
1
TX+
5
not used
2
TX-
6
RX-
3
RX+
7
not used
4
not used
8
not used
Connector Pin Description Pin Description
1 Video Ground 11 RS232 RXD - Data
2 GND - Audio 2 Mic 12 Composite Video In
3 Mic 2 Input 13 GND - Audio 1 Mic
4 Mic Bias 1 14 Mic 2 Line Input
5 GND - Mic 1 Shield 15 Mic Bias 2
6 N/C 16 GND - Mic 2 Shield
7N/C 17N/C
8N/C 18N/C
9 GND - RS232 19 GND - RS232
10 RS232 RXD - Control 20 RS232 TXD - Control
21 RS232 TXD - Data
Connector Pin Description
1 +11—+32 Vdc
2 +11—+32 Vdc
3 Ground
4 Ground
1
8
110
11
21
1
2
3
4