User Manual

1-8
HDT-1000S2 User and Technical
Rev 1
5.2 Selecting the Audio Input Level
The HDT-1000S2 recalls the most recently saved audio input level setting when it is powered
up. To select the input level for Audio 1 and Audio 2 between microphone or line level, do the
following:
1. Press the AUDIO 1 MIC/LINE or AUDIO 2 MIC/LINE key. The currently selected audio
level LED flashes.
2. Press AUDIO 1 MIC/LINE or AUDIO 2 MIC/LINE key to toggle between MIC or LINE
level.
3. Press the SAVE key. The audio level LED flashes to indicate the audio input level was
selected and the LED is illuminated to indicate MIC or LINE level setting.
If the SAVE key is not pressed within 5 seconds, the audio level returns to the most recently
used value and the selection mode is canceled.
5.3 Selecting the RF Output Level
The HDT-1000S2 recalls the most recently saved RF output power level when it is powered up.
To select between high or low power for the RF output level, do the following:
1. Press the RF HI/LOW key. The currently selected RF Power setting is displayed.
2. Press RF HI/LOW key to toggle between HI or LOW RF output level.
3. Press the SAVE key to select the new RF Power output setting.
If the SAVE key is not pressed within 5 seconds, the RF output level returns to the most recently
used value and the selection mode is canceled.
Note
The high power setting is the FCC limit of 0.125W maximum, the low power
setting is approximately 0.05W.