User Manual
Table Of Contents
- Notices
- Contents
- Introduction
- Product Description
- Routine Operation
- 3.1 Chapter Overview
- 3.2 Overview of Controls
- 3.3 Function Buttons
- 3.4 Status LEDs
- 3.5 Display and Keypad
- 3.6 Frequently Performed Tasks
- 3.6.1 Turning the power ON and OFF
- 3.6.2 Activating and deactivating the transmitter
- 3.6.3 Switching between HI and LOW power
- 3.6.4 Selecting Channel and Offset
- 3.6.5 Switching between antennas
- 3.6.6 Switching antenna polarization
- 3.6.7 Switching bands
- 3.6.8 Switching between Analog and Digital modes
- 3.6.9 Setting for Remote operation
- 3.7 Menu Maps
- Channels & Frequencies
- Glossary
- Index
Glossary B-4CodeRunner 2 Operator’s Guide/Tech Ref Manual
Site ID A physical location where any number of modems,
transmitters, or receivers are installed.
SMPTE Society of Motion Picture and Television Engineers
SNR Signal-to-Noise Ratio
STDBY Standby.
Subcarrier An electromagnetic signal that is used as a medium
for placing an information channel above another
information channel.
S-Video Video signal in which the chrominance (color) and
luminance (brightness) information are separated
into separate subcarrier signals. Also called Y/C
Video. Composite Video combines them into one
signal.
SYNTH Synthesizer
T1 1.544 Mbps traffic rate.
Tx Transmitter.
VCO Voltage Controlled Oscillator.
VCXO Voltage Controlled Crystal Oscillator.
VDC Volts Direct Current.
VF Voice Frequency.
Video A term pertaining to the bandwidth and spectrum of
the signal that results from television scanning and
which is used to reproduce a picture.
Xmitr Transmitter.
Xmtr Transmitter.
Y/C Video signal in which the chrominance (color) and
luminance (brightness) information are separated
into separate subcarrier signals. Also called S-Video.
Composite Video combines them into one signal.
Table B-1: Useful Terms (Continued)