User Manual
Table Of Contents
- Notices
- Contents
- Introduction
- Product Description
- Routine Operation
- 3.1 Chapter Overview
- 3.2 Overview of Controls
- 3.3 Function Buttons
- 3.4 Status LEDs
- 3.5 Display and Keypad
- 3.6 Frequently Performed Tasks
- 3.6.1 Turning the power ON and OFF
- 3.6.2 Activating and deactivating the transmitter
- 3.6.3 Switching between HI and LOW power
- 3.6.4 Selecting Channel and Offset
- 3.6.5 Switching between antennas
- 3.6.6 Switching antenna polarization
- 3.6.7 Switching bands
- 3.6.8 Switching between Analog and Digital modes
- 3.6.9 Setting for Remote operation
- 3.7 Menu Maps
- Channels & Frequencies
- Glossary
- Index
Channels & Frequencies A-6CodeRunner 2 Operator’s Guide/Tech Ref Manual
A.3 US 12 MHz Channel Plan
Here are the frequencies that will be used in the new US 12 MHz
channel plan. Your CR2 is pre-programmed with the frequencies
listed in Section A.2 on page A-1. However, as your station
migrates to the new channel plan, you can easily reprogram your
CR2 using the Channel Plan Menu, found under the “Mod CP”
option on the Main Menu screen. See the “Advanced Operation”
chapter of the CR2TechnicalReferenceManual.
Information below was obtained from the FCC Web site,
document # FCC 03-280:
http://hraunfoss.fcc.gov/edocs_public/attachmatch/FCC-
03-280A1.pdf
Table A-5: US 12 MHz Channel Plan
Frequencies (MHz)
Channel
Width
Description
Lower Upper
2025.0 2025.5 500 kHz Lower Data Return Link (DRL) Band
2025.5 2037.5 12 MHz Channel A1r
2037.5 2049.5 12 MHz Channel A2r
2049.5 2061.5 12 MHz Channel A3r
2061.5 2073.5 12 MHz Channel A4r
2073.5 2085.5 12 MHz Channel A5r
2085.5 2097.5 12 MHz Channel A6r
2097.5 2109.5 12 MHz Channel A7r
2109.5 2110.0 500 kHz Upper Data Return Link (DRL) Band