User Manual
Table Of Contents
- Notices
- Contents
- Introduction
- Product Description
- Routine Operation
- 3.1 Chapter Overview
- 3.2 Overview of Controls
- 3.3 Function Buttons
- 3.4 Status LEDs
- 3.5 Display and Keypad
- 3.6 Frequently Performed Tasks
- 3.6.1 Turning the power ON and OFF
- 3.6.2 Activating and deactivating the transmitter
- 3.6.3 Switching between HI and LOW power
- 3.6.4 Selecting Channel and Offset
- 3.6.5 Switching between antennas
- 3.6.6 Switching antenna polarization
- 3.6.7 Switching bands
- 3.6.8 Switching between Analog and Digital modes
- 3.6.9 Setting for Remote operation
- 3.7 Menu Maps
- Channels & Frequencies
- Glossary
- Index
Product Description 2-10CodeRunner 2 Operator’s Guide/Tech Ref Manual
2.7.3 Dual Band Simultaneous Transmitting
Figure 2-7 shows the antenna configuration for simultaneous
transmitting using two Indoor Units with two RF Units.
In this example the RFUs are operating on 2 GHz and 7 GHz
bands, but the 13 GHz band is also available as one of the two
bands.
In addition, an RF Switch allows switching one of the RF Units
between an OmniPole and a directional antenna.
Figure 2-7: Dual Band Simultaneous Operation
OmniPole
RFU
1.99-2.5 GHz
70 Mhz
IF +
POWER +
CONTROL
70 Mhz
IF +
POWER +
CONTROL
RFU
6.4-7.1 GHz
CodeRunner 2 IDU
70 MHZ IF
ENCODER / COFDM
MODULATOR
NYCOIL CONDUIT
POLARIZATION
SWITCH
CodeRunner 2 IDU
70 MHZ IF
MPEG
ENCODER / COFDM
MODULATOR
MPEG Encoder &
COFDM Modulator
MPEG Encoder &
COFDM Modulator
Directional
MPEG
RF SWITCH
2 Analog Audio
2 Analog Audio
Analog Video
Analog Video
Digital Video + Audio
SDI
DVB/ASI
Digital Video + Audio
SDI
DVB/ASI
2 Analog Audio
2 Analog Audio
Analog Video
Analog Video
Digital Video + Audio
SDI
DVB/ASI
Digital Video + Audio
SDI
DVB/ASI
ANTENNA SWITCH
POWER & CONTROL