User Manual
Table Of Contents
- Notices
- Contents
- Introduction
- Product Description
- Routine Operation
- 3.1 Chapter Overview
- 3.2 Overview of Controls
- 3.3 Function Buttons
- 3.4 Status LEDs
- 3.5 Display and Keypad
- 3.6 Frequently Performed Tasks
- 3.6.1 Turning the power ON and OFF
- 3.6.2 Activating and deactivating the transmitter
- 3.6.3 Switching between HI and LOW power
- 3.6.4 Selecting Channel and Offset
- 3.6.5 Switching between antennas
- 3.6.6 Switching antenna polarization
- 3.6.7 Switching bands
- 3.6.8 Switching between Analog and Digital modes
- 3.6.9 Setting for Remote operation
- 3.7 Menu Maps
- Channels & Frequencies
- Glossary
- Index
Product Description 2-8CodeRunner 2 Operator’s Guide/Tech Ref Manual
2.7 System Configurations
The CodeRunner allows several antenna configurations for
transmitting with either an OmniPole or directional antenna, in
either single-band or dual-band operation.
2.7.1 Single Band/Dual Antenna Configuration
Figure 2-6 shows the antenna configuration for single-band
transmitting using one Indoor Unit with one RF Unit.
The RFU could be operating on the 2 GHz, 7 GHz, or 13 GHz
bands.
In addition, an RF Switch allows switching between an OmniPole
and a directional antenna.
Figure 2-5: Single Band Operation with 2 Antennas
MRC RF SWITCH
OmnPole
CodeRunner 2
RFU
CodeRunner 2
IDU
70 Mhz
IF
+ CONTROL
+ POWER
COFDM
MODULATOR
ASI
ANTENNA
SWITCH
POWER &
CONTROL
NYCOIL CONDUIT
MPEG Encoder &
COFDM Modulator
MPEG ENCODER/
Directional
2 Analog Audio
2 Analog Audio
Analog Video
Analog Video
Digital Video + Audio
SDI
DVB/ASI
Digital Video + Audio
SDI
DVB/ASI