User Manual
Table Of Contents
- Notices
- Contents
- Introduction
- Product Description
- Routine Operation
- 3.1 Chapter Overview
- 3.2 Overview of Controls
- 3.3 Function Buttons
- 3.4 Status LEDs
- 3.5 Display and Keypad
- 3.6 Frequently Performed Tasks
- 3.6.1 Turning the power ON and OFF
- 3.6.2 Activating and deactivating the transmitter
- 3.6.3 Switching between HI and LOW power
- 3.6.4 Selecting Channel and Offset
- 3.6.5 Switching between antennas
- 3.6.6 Switching antenna polarization
- 3.6.7 Switching bands
- 3.6.8 Switching between Analog and Digital modes
- 3.6.9 Setting for Remote operation
- 3.7 Menu Maps
- Channels & Frequencies
- Glossary
- Index
Product Description 2-6CodeRunner 2 Operator’s Guide/Tech Ref Manual
Table 2-1: IDU Rear Panel Connections
Connector Function
Summary Alarm Input Alarm input from external device such as
a modulator.
Analog Video Input Input for analog video.
Baseband Input Input from external baseband source.
Audio Input Line level analog audio input.
Data In/Out Can be used as either input or output for
digital video (DVB-ASI). Configured via
menus on front panel display.
IF Input IF input from external modulator
RF Outputs 1 and 2 • IF + DC Power + Control to RFU
(Triax Connector option)
• IF + Control to RFU (Type ‘N’ and
TNC connector option)
Pan & Tilt Control Not Used
Power Input Supply power to CodeRunner 2 system
(both IDU and RFU).
Grounding Lug Connection to chassis ground
RFU Power Output DC Power to RFU 1 and RFU 2 (only
present with Type ‘N’ and TNC connection
options).
Antenna Control
• FEED POWER
• FEED/RELAY
POWER
• Control for antenna polarization,
antenna band, and RF Switch.
• Power for antenna and RF Switch.
Video Monitor Output Analog video output to monitor the analog
Color Bar Generator. Does not contain
program video.
Host Serial Port RS-232 data
Auxiliary Serial Port RS-232 data
Table 2-1: IDU Rear Panel Connections (Continued)
Connector Function