User Manual
Table Of Contents
- Notices
- Contents
- Introduction
- Product Description
- Routine Operation
- 3.1 Chapter Overview
- 3.2 Overview of Controls
- 3.3 Function Buttons
- 3.4 Status LEDs
- 3.5 Display and Keypad
- 3.6 Frequently Performed Tasks
- 3.6.1 Turning the power ON and OFF
- 3.6.2 Activating and deactivating the transmitter
- 3.6.3 Switching between HI and LOW power
- 3.6.4 Selecting Channel and Offset
- 3.6.5 Switching between antennas
- 3.6.6 Switching antenna polarization
- 3.6.7 Switching bands
- 3.6.8 Switching between Analog and Digital modes
- 3.6.9 Setting for Remote operation
- 3.7 Menu Maps
- Channels & Frequencies
- Glossary
- Index
Product Description 2-5CodeRunner 2 Operator’s Guide/Tech Ref Manual
2.5 External Connectors
All transmitter connections are made at the rear panel of the
IDU. The panel layout is shown in Figure 2-4.
Brief descriptions of the connections are found in Table 2-1. For
more detailed information, see the MRCCodeRunner2
TechnicalReferenceManual.
Figure 2-4: Rear Panel Connectors
BB IN
VIDEO IN
AUX RS232
BAND 2
ANT 2
+
RFU 2
RFU 1
~POWER
50-60 Hz
120-240V AC
2A - 120V AC
1A - 240V AC
FEED/
RELAY
POWER
HOST RS232
V MON. OUT
AUDIO 1AUDIO 2
IF INDATA IN PAN/TILT
FEED
MOD SUM ALM
POWER
V
H
LCP
GND
+24V
GND
RF UNIT
PWR OUT
--
++
--
++
RFU1 RFU2
RF
SWITCH