User Manual
Table Of Contents
- Notices
- Contents
- Introduction
- Product Description
- Routine Operation
- 3.1 Chapter Overview
- 3.2 Overview of Controls
- 3.3 Function Buttons
- 3.4 Status LEDs
- 3.5 Display and Keypad
- 3.6 Frequently Performed Tasks
- 3.6.1 Turning the power ON and OFF
- 3.6.2 Activating and deactivating the transmitter
- 3.6.3 Switching between HI and LOW power
- 3.6.4 Selecting Channel and Offset
- 3.6.5 Switching between antennas
- 3.6.6 Switching antenna polarization
- 3.6.7 Switching bands
- 3.6.8 Switching between Analog and Digital modes
- 3.6.9 Setting for Remote operation
- 3.7 Menu Maps
- Channels & Frequencies
- Glossary
- Index
Product Description 2-4CodeRunner 2 Operator’s Guide/Tech Ref Manual
2.4 Operating Controls
All controls are on the front panel of the IDU. There are no
controls or adjustments on the ODU (RFU).
All transmitter functions are controlled using an LCD display with
8 button keypad, and a set of 3 function switches. See Figure 2-3
on page 2-4.
The LCD display and keypad are used to toggle through control
and diagnostic menus for both the IDU and ODU.
Functions switches directly control antenna polarization, band
selection, and antenna selection.
Figure 2-3: Front Panel Controls
POWER
IDU ALARM
PA ON
RFU ALARM
BAND
SELECT
POLARIZATION
ANT 1
ANT 2
RFU 1
RFU 2
LC
RC
H
V
TRANSMITTER
MRC CODERUNNER 2-C/M
Function Buttons
Display
Keypad
LED Indicators
Polarization Select Band Select Antenna Select