Specifications

MDS 05-4055A01, Rev. A MDS entraNET 900 System Guide 83
4.1.4 Detailed Command Descriptions
HELP
Lists commands supported for the current user login level.
ALARM
[<LEVEL>, HEX=]
This command displays the current alarm conditions by level. For each
level, the specific events that caused the alarm are listed underneath
along with brief descriptions. Alarm levels are:
ALL—All alarm classes
INFORM—Non-persistent information
MAJOR—Major alarm
CRITICAL—Critical alarm
Optional Arguments:
HEX= Read Only information. Displays the Alarm Hex Bits-Codes. It
lists the hex bit codes for the current alarm condition by class. For each
specific event that causes an alarm, the corresponding bit is set. Event
numbers are matched to the appropriate hex code by a relationship of 2
n
.
APLIST
[CLEAR, RESTRICT=<restrict>, APx=apx, CMD=<cmd>]
Sets/displays the serial numbers of up to ten APs with which the Remote
should accept registration. A serial number of “0” indicates the slot is
empty.
Optional Arguments:
CLEAR—Clears all entries in the AP list.
RESTRICT=<restrict>—Turns on/off restricting registration to access
points. ON: Restricts registration to approved AP list, OFF: Does not
restrict registration to approved AP list.
PROGRAM
Allows a boot to the bootloader
RADIO
Set/display the radio configuration and status
REBOOT
Restart the radio’s firmware
SLEEP
Selects one of the low power operating modes: Sleep, Shutdown
STATS
Shows radio statistics
VER
Set/display the current version information
Table 4-1. Remote Commands—Quick Reference (Continued)
COMMAND DESCRIPTION