Specifications

24 GE MDS entraNET Reference Manual 05-4055A01, Rev. D

• hardware flow control disabled

• VT100 emulation

NOTE: The exact parameters given above must be used for console

terminal communication. Improper settings are a common

cause of difficulty.

Invisible place holder

Figure 2-6. Remote Configuration Setup

3. Press several times to receive the entranet> prompt. (The

COM1/ETH LED blinks to indicate data communication.)

4. At the entranet> prompt, enter login. Press .

5. At the next prompt, enter the username (the default username is

admin). Press .

6. At next prompt, enter the password (the default password is admin).

Press . The radio is now ready to accept commands.

Set or Verify Network Address

The only setting normally required for initial checkout of a Remote

radio is the network address. All radios in a given network must be pro-

grammed with the same network address as the AP, or communication

is impossible. Follow the steps below to check the address, and program

a new one if necessary.

1. Enter the

RADIO NETADDR= command. This displays the currently

programmed network address.

2. If changes are required, enter the

RADIO NETADDR=<netaddr> com-

mand, where <netaddr> is 1-15 alphanumeric characters. (The net-

work address of the Remote radio must match that of the AP.)

3. Verify that the

LINK LED lights to indicate successful connection

with the AP. (It may take several seconds for the LED to light.)

PC Running Terminal Session

(19,200 bps, 8N1)

LIN

COM

Remote

COM1 Port

ENTER