Specifications

116 GE MDS entraNET Reference Manual 05-4055A01, Rev. D
SHUTDOWN: Shutdown mode is enabled. In this mode, the radio
draws less than 1 mA at a supply voltage of 12 Vdc. Note that
this mode requires a longer wake-up time—almost as long as if
the radio were de-powered.
NOW=<setting>—This command is used to place the radio into immediate
Sleep or Shutdown mode.
Sleep: The radio immediately enters Sleep mode.
Shutdown: The radio immediately shuts down, drawing less than
1 mA at a supply voltage of 12 Vdc.
WAKE=<dtr, data>—Selects a control option to activate (enter) or deacti-
vate (exit) Sleep or Shutdown modes.
DTR: Wake under DTR signal control
DATA: Wake up on data
STATS Displays radio statistics. If <device> (RADIO,COM1,COM2,ETH) is omitted,
all statistics are displayed.
Optional arguments:
ALL: Displays all statistics
RADIO: Displays radio packet statistics
COM1: Displays COM1 packet statistics
COM2:Displays COM2 packet statistics
ETH: Displays Ethernet packet statistics
RESET: Resets packet statistics for the indicated interface
STATTRACKER When the STATTRACKER mode is turned on, the Remote transceiver
sends out UDP packets with a broadcast destination IP address. The
command has a user-defined port number between 30000 and 60000,
and sends packets consisting of:
The source MAC address in the UDP packet is the MAC address from
the entraNET AP. These monitoring packets are sent out every time
there is over-the-air traffic.
This command is designed to work with the GE MDS Mobility Applica-
tion available from GE GE MDS (Part No. 06-4157A01).
• RSSI statistics • Receive byte errors
• Connectivity • Transmit byte errors
• Packets received • Total fragments
• Packets transmitted • Total retries
• Packets dropped
• Bytes received
• Bytes transmitted