Specifications

05-4055A01, Rev. D GE MDS entraNET Reference Manual 103
4.5.1 Detailed Command Descriptions
ALARM Displays the current alarm conditions by severity level. For each level,
the specific events that caused an alarm are listed, along with a brief
description of each alarm. Alarm levels are:
ALL—All alarm classes
INFORM—Non-persistent information
MINOR—Minor alarm
MAJOR—Major alarm
CRITICAL—Critical alarm
Optional argument:
HEX= —Displays the hex bit codes for the current alarm condition by
class. For each specific event that causes an alarm, the corresponding bit
is set. Event numbers are matched to the appropriate hex code by a rela-
tionship of 2
n
.
APLIST Configures a list of approved APs.
Optional arguments:
Table 4-1. Remote Commands—Quick Reference
COMMAND DESCRIPTION COMMAND DESCRIPTION
_? (after a com-
mand)
When entered after a command in this list,
shows detailed information and allowable
entries
HELP
Lists commands supported for the logged-in
user. (See also the
? command at the begin-
ning of this table.)
ALARM
Displays current alarm conditions by class
LOG
Sets or displays the event log information
APLIST
Sets or displays serial numbers of up to 50 APs
with which the Remote can associate
LOGIN
Secure log-in. Prompts for the case-sensitive
username and password.
AUTH
Sets or displays the Authorization Key and a list
of authorized features
LOGOUT
Logs the user off and ends the terminal session
COM1
Sets or displays the configuration of COM1 port
(baud rate, data format, buffer size,
inter-packet gap)
MESSAGE
Sets the default priority level for message pack-
ets (low, normal, high)
COM2
Sets or displays the configuration of COM2 port
(baud rate, data format, buffer size,
inter-packet gap)
PASSWORD
Sets the user log-in password for the user at
current access level or below
CONFIG
Shows the dump configuration of all settable
parameters
PROGRAM
VERIFY
Performs a checksum verification on one of six
parameters
DEVICE
Sets or displays the device configuration,
including owner, company, and serial number
RADIO
Sets or displays the radio configuration and sta-
tus
DIRECT
Sets or displays the configuration for direct
mode operation
REBOOT
Restarts the radio firmware
ENCRYPT
Sets or displays the configuration for data
encryption
SLEEP
Sets the low-power operating mode: Sleep or
Shutdown
ETH
Sets or displays the Ethernet port configuration
STATS
Shows radio statistics
HANDOFF
Sets or displays the hand-off configuration
STAT-
TRACKER
When enabled (STATTRACKER ON), sends
UDP packets from the Ethernet port on the
Remote radio every time a wireless packet is
received
VER
Displays the current version number