Specifications

98 GE MDS entraNET Reference Manual 05-4055A01, Rev. D
Figure 3-63. DNP3 Routing Menu
• DNP Routing Enable—Enables or disables the DNP3
routing function. [Enabled, Disabled; Disabled]
• DNP Multicast Address—Specifies the group address with which
to exchange UDP-encapsulated messages with other IP devices
that are DNP3 aware. This includes PCs, endpoint devices, and
other APs. When a DNP3 packet is received and no routing
information exists for the target device (see DNP3 routing data-
base
below), the AP sends the packet to all other IP devices in
an attempt to find a radio that recognizes the address. [Valid IP
address; 224.254.1.1]
• DNP Multicast Port—Specifies the IP port number used for all
DNP3 Multicast messaging. [0-65535; 20000]
•
DNP Unicast Port—This field specifies the IP port number used to
establish a socket to other IP devices. This UDP port (along with
the AP local IP address) is used to encapsulate DNP3 messages
over IP. [0-65535; 20001]
•
DNP3 Routing Database—This selection brings up a screen where
the current DNP3 routing information known by the AP can be
viewed.
NOTE: For installations that include multiple APs, it is important to
properly configure IAPP, which is located within the Mobility
Menu. IAPP allows APs to share their DNP3
routing information.