Specifications

Touch Controllers Reference Guide74
Reset
Syntax: <SOH>R<CR>
Description: Initializes the hardware and the firmware, causes the controller to stop
sending data, and recalculates the environmental conditions (for
example, stray and offset values). The Reset command also cancels
the Format Raw and Calibrate Raw commands and returns the
controller to normal operation.
MicroTouch recommends that the host system issue a Reset command
whenever the host system is powered on and is attempting to establish
communication with the controller.
Depending on the controller, the amount of time needed to execute a
Reset command ranges from 225 milliseconds to 800 milliseconds.
Therefore, the application program should wait and be sure it receives
the command response before issuing another command to the
controller following the reset.
Response: <SOH>0<CR> Positive response.