Specifications

Touch Controllers Reference Guide56
Get Parameter Block
Description: Allows access to all power-up and run time parameters used by the
controller.
The Get Parameter Block (GP) command works in conjunction with
the Set Parameter Block (SP) command. You use this pair of
commands for configuration and diagnostic purposes.
You use the Get Parameter Block command to retrieve the
parameters. You then use the Set Parameter Block command to
modify the data and write the data back to the controller. The blocks
include calibration and initialization data, linearization data, and run
time variables.
Command syntax and controller block details are not provided in this
manual because the block data is subject to change with each firmware
release and because block changes using the SP command may cause
system problems. For information about command syntax and block
descriptions, contact MicroTouch.