Specifications

Chapter 2 Firmware Commands 35
The value of the positive response for the upper right touch point
varies depending on whether you are using Format Binary, Format
Tablet, Format Decimal, or Format Hexadecimal.
In general, the positive response is <SOH>1<CR> and the negative
response is <SOH>0<CR>. There are, however, two exceptions to
this rule. If you are using Format Decimal or Format Hexadecimal,
the positive response is <SOH>0<CR> and the negative response is
<SOH>1<CR>.
Table 7 lists the positive and negative responses returned for each
calibration point (lower left and upper right) based on the data format
being used.
Table 7. Response Values for the Calibrate New Command
Response Format Binary
or
Format Tablet
Format Hexadecimal
or
Format Decimal
Lower Left Positive <SOH>1<CR> <SOH>1<CR>
Lower Left Negative <SOH>0<CR> <SOH>0<CR>
Upper Right Positive <SOH>1<CR> <SOH>0<CR>
Upper Right Negative <SOH>0<CR> <SOH>1<CR>