Specifications

Chapter 2 Firmware Commands 25
Table 5. MicroTouch Touch Controller Firmware Commands
Command Name
ASCII Code
SMT2
1
,
PC Bus SMT2
SMT3V
1
, SMT3RV,
PC Bus SMT3RV
PC Bus SMT3V
SMT3, SMT3R,
MousePort
TouchPen 4
TouchPen 4+
Default Settings
N72, 9600
AE, FD, MS
N72, 9600
(AD/AE)
2
, FD, MS
N81, 9600
FT, MS
N81, 9600
FT, MS, PF
AutoBaud Disable
AD
Note 2
AutoBaud Enable
AE
Note 2
Calibrate Extended
CX
Calibrate Interactive
CI
Calibrate New
CN
Calibrate Raw
CR
Filter Number
FN
nn
Finger Only
FO
Note 3 Note 3
Format Binary [Stream]
FB[S]
Format Decimal
FD
Format Hexadecimal
FH
Format Raw
FR
Format Tablet
FT
Format Zone
FZ
Frequency Adjust
<Ctrl C>F
nn Note 4
Get Parameter Block
GP
n
Mode Down/Up
MDU
Mode Inactive
MI
Mode Point
MP
Mode Polled
MQ
Mode Status
MT
Mode Stream
MS
Null Command
Z
Output Identity
OI
Output Status
OS
Parameter Lock
PL
Parameter Set
P
pds
[
b
]
Pen Only
PO
Pen or Finger
PF
Reset
R
Restore Defaults
RD
Sensitivity Set
SE
n
Set Parameter Block
SP
n
Unit Type
UT
Unit Type Verify
UV
1. SMT2 includes the SMT2 Daughterboard; SMT3V includes the SMT3V Daughterboard.
2. All firmware versions support the AD command. The AE command is available only in version 5.4 and later.
The PC Bus SMT3V controller uses AE as the default; the other controllers use AD.
3. Returns a 0 response, which indicates the controller received a valid command. However, the specified
controllers perform no function when receiving the command. Provided for compatibility only.
4. Available only in firmware version 5.5 and later.