Specifications

Index 119
Serial/SMT touchscreen cable
connector 91
TouchPen connectors 103
PL (Parameter Lock) command 68
PO (Pen Only) command 71
point mode 59
polled mode 60
positive response 21
power requirements
Daughterboard controller 107, 111
PC Bus controller 95
Serial/SMT controller 90
TouchPen controller 102
power-up sequence 19
Ppdsb (Parameter Set) command 69
proximity bit 37, 51
Q
query mode 60
R
R (Reset) command 74
rate See communication rate
raw data
calibration 36
format 48
RD (Restore Defaults) command 75
receive data (RXD) 20
recommendations
communication rates with pens 16
firmware command 24
Reset command 74
responses from the controller 21
Restore Defaults command 75
RXD (receive data ) 20
S
SE (Sensitivity Setting) command 77
sending firmware commands 20
sensitivity of touch, adjusting 77
Sensitivity Setting command 77
sensor cable connector 91
sensor drive signal, adjusting 54
Serial/SMT controllers 87
Set Parameter Block (SP) command 78
settings See parameters
signal frequency 54
size
Daughterboard controller 107
PC Bus controller 95
Serial/SMT controller 90
TouchPen controller 102
SMT controllers 87
SOH (start-of-header) character 20
SP (Set Parameter Block) command 78
specifications
Daughterboard controller 107
PC Bus controller 95
Serial/SMT controller 90
TouchPen controller 102
status
controller hardware 67, 79, 81
touch 62
status light on controller 83
status mode 62
stop bits, setting number of 69
stream mode 64
successful command response 21
support, technical 8
syntax, command 20