Specifications

Touch Controllers Reference Guide114
Electrostatic Discharge (ESD) Considerations
You should test your completed board layout for general design as
well as ESD in accordance with the IEC 801-2 specification. In
general, ESD characteristics are different for each design.
Disclaimer: This chapter describes a means by which you can make
the connections. It does not guarantee that your board design will
pass ESD testing. MicroTouch is not liable for design problems.
The suggested ESD protection diodes are as follows:
Type: MMBD7000 dual diodes
Size: SOT-23 case
Quantity: 5
Ordering Information
Table 24 lists the connectors you need to integrate the MicroTouch
Daughterboard controller onto a system board. To order these
connectors, contact Molex Incorporated at the following address:
Molex Incorporated
2222 Wellington Court
Lisle, Illinois 60532
[phone]
Table 24. Connectors Required on the System Board
Connector Description Molex Part Number
Male connector for mounting the touchscreen cable 8624-10-88-1121
Female connector for mounting the Daughterboard
controller
70182-15-45-0907