User`s guide

Virtual CD v4 Documentation
Page 25 of 25
shows only your virtual CD-ROM drives, as was the case in the earlier Virtual CD
program versions (see page 34).
The upper half of the right-hand pane shows all of the virtual CDs that are registered
(see below) in the Management program. The lower half shows the contents of the
selected virtual CD.
Adding Existing Virtual CDs to the Management
Program
When Virtual CD is first installed, it doesn't "know" about any virtual CDs you may
already have on your hard disk. Existing virtual CDs have to be added to the
Management program, or "registered", before you can use them.
When you select the Find function in the Virtual CD Management program, Virtual
CD searches your system for existing virtual CDs. The CDs found are presented in a
selection dialog, so you can define which ones are added.
To add CDs, start by clicking on the
button to open the "Find..." dialog. Enter
the path to be searched under Search in:..
Under Virtual CD files you can restrict the search to certain file types. You can
choose between container files from earlier Virtual CD versions and .ISO files, which
are created by CD-R programs. Click on Start searching when you are ready to start
the search; all CDs found are shown in the box at the bottom of this dialog.
From the files listed, you can select the desired containers and click on Add selected
image files to register the corresponding virtual CDs in the Virtual CD Management