User guide

DiscView PRO User Guide

C-2

DiscPort Configuration Using The DOS Utilities

This document assumes that:

ü you have copied the DP*.IMG files to the “\login” direc-

tory

ü you have installed the DiscView server components (*.dsk,

*.nlm, *.ncf files) to the \system\discport.cd directory

ü the DiscPort host is powered on and is connected to the

network cable

All commands are issued from the DiscView directory using

the DP.EXE executable file. If you specified a directory name

other than discview when you ran the install.bat file from

disk 1 (install c:\discview), go to that directory. If you

performed the initial installation from Windows, the directory

name is \discview\dosutil.

1. Command: dp discport list

This command will return a screen similar to the one be-

low. Initially, your DiscPort will be listed as unconfigured.

The status light on the DiscPort will blink four times am-

ber if the DiscPort is unconfigured.

2. Command:

dp discport config <bootserver> <discport_address>

Example:

dp discport config support discport_402B06 dpe330a.img

This command will set the boot server and the boot image file,

and display a screen similar to the screen at the top of the

following page. The discport_address is found on the bottom of

the DiscPort unit. It is the last six digits of the address code.