User guide

Chapter Eight – Jukebox Support
133
13. Check to make sure the default jukebox name listed on
this dialog is correct.
Important! Do not change the default name unless you
know for sure that the jukebox name has been changed
through the jukebox manufacturer’s utilities.
14. Click Next to display the Step 6 dialog (or Step 3 Pioneer
dialog).
15. Set the Reserve Time based on the following description.
Reserve Time is used only when the number of users
simultaneously requesting access to different CDs in the
same jukebox exceeds the number of read heads in the
jukebox.
For example, your jukebox has two read heads, but three
users request access to the CDs. That's when Reserve
Time goes into effect, allowing all three users to read
information from their requested CD by scheduling CD
reads based on the Reserve Time. The first CD will be
read for the specified length of Reserve Time, then the
next CD is placed in the drive and read for the specified
time, and so on, back and forth, until all the required data
are read. You can set a Reserve Time limit from five to 60
seconds. Ten seconds is the recommended setting to
preserve data integrity.
16. Click Next to display the final dialog, Step 7 (NSM), or
Step 4 (Pioneer).
The NSM Jukebox Configuration
Step 6