User guide

Chapter Eight – Jukebox Support
131
5. Enter the correct serial port number (use the up or down
arrows to select a number from 0 to 4). If you choose to
keep the default setting of 0, the first available serial port
will be used.
6. In the field labeled Comm Board, enter the board
number you jotted down when you loaded the AIO driver
at the fileserver. Specifying -1 attempts to use the first
Comm board found.
7. Click Next. The Step 3 dialog displays.
8. Enter the appropriate Host Adapter number from 0
through 6. This is the number of the SCSI card controlling
the jukebox.
9. Enter the Phantom Target ID number. This must be a
unique number. It can be any unused SCSI ID from 0
through 6. The drives in the jukebox might be set to 3, 4,
5, and 6, therefore you could use 0, 1, or 2 for the
Phantom Target ID.
When using an RS-232 (serial) jukebox, the Phantom ID
provides a SCSI ID to the DiscView software, allowing
DiscView to work with such jukeboxes.
10. Click Next to display the Step 4 dialog.
The NSM Jukebox Configuration
Step 3