User guide

Chapter Eight – Jukebox Support
123
NSM CDR 100 XA Jukebox
The RS-232, or Jukebox ID, for the CDR 100 XA is set using
one of the two dials on the interface board on the inner back
panel of the unit. See the manufacturer's user manual for
instructions on accessing the board. Use a small screwdriver
to turn the switch to the position that represents the desired
ID number.
The manufacturer's factory default for the DIP switch
(S3) is all off. Switch 7 controls the sending ACKN
block. Operational performance can be improved by
setting this switch ON.
INTERFACE
ST1
ST5
ST6
ST3
ST4
ST2
S1
S2
S3
JP1
1
2
3
RS232 IDs
0 F
SCSI ID
0 6
RS232 ID
SCSI ID
DIP SWITCH
ON
8 7 6 5 4 3 2
1
6
4
2
0
8
A
C
E
5
6
1
2
7
8
0
9
4
3
Using a small screwdriver,
turn the appropriate dial to
the desired ID number
(SCSI, or RS-232).
The RS-232 ID is the
Jukebox ID called for in
the DiscView Jukebox
Driver installation process.
It should be less than or
equal to 9.