User guide

DiscView PRO User Guide
122
Dipping the Switches and Other Guilty Pleasures
The information we have provided regarding switch settings
is for your convenience and may not apply to a particular unit.
Always refer to the manufacturer's instructions to confirm the
settings described here.
NSM Mercury 40 Jukebox
The RS-232 ID, the Jukebox ID, for the Mercury 40 is set
with the buttons on the front panel of the jukebox. The
following basic instructions should help you set the RS-232
ID. Please refer to the manufacturer's user manual for more
detailed information.
Setting the Jukebox ID (RS-232)
1. Switch the jukebox ON while holding the F button until
"Power On Menu, Function?" appears. (Be sure to unlock
the keylock.)
2. Press the 3 button. The display changes to
"Set RS-232 ID 00."
3. Press ï or ð to scroll the ID number up or down. This
number must be less than or equal to 9.
4. Press the à button. The display reads "RS-232 ID set 07,"
or whatever number you used.
5. Turn the jukebox power OFF, then back ON.
Setting the SCSI ID of the Internal CD-ROM Drives
The four CD-ROM drives in the Mercury 40 are assigned
SCSI IDs 3, 4, 5, and 6 as factory defaults. The manufacturer
recommends that the SCSI IDs of the drives not be changed.
If, for some reason, you feel you have a SCSI bus conflict that
can be avoided only by changing the SCSI ID of one or more of
the internal CD-ROM drives, please contact an authorized
NSM service representative.