User guide

OMNIScanner User Guide
A - 2
OMNI Fiber LED Displays
· 850 nm Indicator (GREEN) for transmitting at 850 nm
· 1300 nm Indicator (GREEN) for transmitting at 1300 nm
· 850 nm Indicator (ORANGE) for switching fibers
· 1300 nm Indicator (ORANGE) for switching fibers
Power
· Removable, rechargeable battery pack
· 9.6 Volts @ 1200 mA-Hr NI-CD
· Built-in fast charger using AC adapter
· Charging Time: 3 hours for fully discharged batteries.
· Battery life : 10+ hours operation (typical)
· AC: 15 VDC - 1 amp AC adapter for continuous operation or charging
Environmental
· Operating Temperature: 0°C to 50°C (32°F to 122°F)
· Storage Temperature: -10°C to 55°C (14°F to 131°F)
· Operating Humidity: (non-condensing): 5% to 90%
· Storage Humidity: 5% to 95%
· Regulatory Compliance: CE Class A
Measurement Port (Test Interface)
· Ultra low Crosstalk test interface that supports testing of all four pairs
· 160 pin test interface connector which exceeds 10,000 mating cycles
· Variety of test cables and adapter modules support testing of 110 block
and shielded modular jack and plug interfaces
Serial Port
· Connector: DB-9
· Baud Rate: 300 to 57,600 baud
· Parity: None
· Length: 8 Bits
· Handshaking: None, RTS/CTS, and XON/XOFF
Memory
· Control: Flash Memory allows electronic upgrading of both OMNI-
Scanner and OMNIRemote programs.
· Test Storage: Up to 1000 complete Autotest results can be stored in
permanent flash memory. They are not subject to loss due to power or
battery failures.