User guide

6 - 3
OMNIScanner User Guide
pass, the test name will be followed a (Fail) symbol.
Note: The list of tests varies depending on the kind of Autotest that was
performed.
(See Chapter 4 - Measurements for detailed information about each
measurement screen.)
Use the éê on your keypad to highlight a test.
Press ENTER to open the test result screen for that
particular test.
Use the ç or è on your keypad to quickly page
through all test results.
Note: If the (Save Graphs) option was selected when saving the
Autotest, graphs associated with NEXT, Attenuation, Return Loss,
PSNEXT, ELFEXT, ACR, PSELFEXT, and/or PSACR are available when
viewing Autotest results. Only the graphs that were selected in the Autotest
Options screen will be saved. (See Chapter 3 - Setup: Autotest Options
for information about selecting graphs to be saved.)
Press ESC to return to the PROJECT NAME screen.
Press ESC to return to the RESULTS screen.
For Fiber Optic Cabling:
The Autotest Results screen will be displayed. The name of the Autotest,
the cable that was used to run the test, and the overall test result ( PASS
or FAIL) for both fibers are shown.
, , or (Loopback) are displayed to inform
you what Method was used to set the reference.
(See Chapter 7 - Fiber Optic Reference for further
information.)
When dual fiber was measured, arrows RQ at the
top of the screen point out the direction of the light.
The arrows also indicate the fiber that the (PASS)
or (FAIL) result is for.