User guide

OMNIScanner User Guide
6 - 2
The previously highlighted PROJECT NAME will now appear in the title bar
together with a numeric test counter that shows the number of Autotest
results stored within the project.
To remove an Autotest from the list press the (Delete) function key.
Press (Edit) to move the Autotest to another project or to change
the Circuit ID.
Press ENTER with the Project: highlighted to reveal
a list of all projects that are currently stored. Use the
éê to highlight the project you want to store the
Autotest within, and press ENTER to select it.
Use the ê to highlight the Circuit ID: and press
ENTER to edit the field. Press ENTER to terminate
the edit mode.
Press (Save) to save the changes and return to the PROJECT
NAME screen. If the PROJECT NAME was changed, it will now appear in
the title bar together with the numeric test counter.
Viewing Autotest Results
To view detailed information about a saved Autotest
use the éê on your keypad to highlight a Circuit ID
in the Project Name screen and press ENTER.
For Twisted Pair Cabling:
The Autotest Results screen will be displayed. The name of the Autotest,
the cable that was used to run the test, and the overall test result (PASS or
FAIL) are shown.
All measurements that were performed during the Autotest are listed in the
left column. Passed tests will be marked with a . If a test result did not