User guide

OMNIScanner User Guide
1 - 6
OMNIRemote’s LED Indicators
LED Color Description
PASS Green Overall Autotest Result
is PASS
Status Green (flashing) OMNIRemote is ready
for testing
Green (consistent) OMNIRemote is active
FAIL Red Overall Autotest Result
is FAIL
Circuit Orange Hazard condition is
Guard detected. LED will be lit
in 5 second intervals
until the hazard
condition disappears
Charge Green OMNIRemote is inactive,
the AC adapter is present,
and the battery pack is
being charged
Green (flashing) OMNIRemote battery is
fully charged
Red (flashing) OMNIRemote battery is low
OMNIRemote Keys
ON/OFF
When turned on OMNIRemote will blink the LEDs.
l l
l l
l (Lambda)
When OMNI Fiber is attached to OMNI Remote , the remote unit can be
used as a light source. With the OMNI Fiber adapter attached, press the
ll
ll
l
key to activate the light source and provide continuous or modulated light at
850 or 1300/1310 nm. The green LED of the appropriate wavelength will
blink rapidly when modulated light is transmitted. If the transmitted light is
continuous, the green LED will not blink. (See OMNIFiber’s LED indicators
in this chapter for further information.)