User guide

MICROTEL CellStat

“set system id ” Configure a custom SMS system text id

Example- Command: “set system id Richfield lift 1”

NOTE: You must enter the “set system id ” portion as shown. That is, there must be

a single space between each word and after “id”.

NOTE: The custom system text id can be up to 16 characters long.

Example- Alarm event: “Richfield lift 1

Channels in Alarm:1,”

NOTE: Display formatting on your

mobile phone may be slightly different.

z Answer Delay The number of rings the dialer will see before answering an incoming

call on the telephone line. NOTE: Incoming calls on the cellular interface are

answered after 1 to 3 rings.

*02 Review answer delay

**02nn Program answer delay

Example- Command: **0205

Response: The telephone answer delay is zero five rings.

z Access Code This 2 digit access code is required to access configuration commands

during a telephone call to or from the dialer.

*03 Review value of access code

**03nn Program access code

NOTE: The factory set default code is ‘12’. Use a 00 access code value to disable

access code requirement. Access code is not required to configure the dialer through

the local PHONE jack.

Example- Command: **0313

Response: The access code is one three.

z Snooze Delay The snooze delay is the time, in hours, after which the dialer will re-

arm an acknowledged alarm and begin calling again as a reminder that the alarm

condition still exists.

*04 Review snooze delay time interval

**04HH Program snooze delay time interval