System information

MICROTEL Series 1000EX Dialer
51
Use the following command syntax to review/set disable timers:
0*2nn* Report disable timer current value
0**2nnDDHHMM* Set disable timer n
DDHHMM (00-99 Days, 00-23 Hours, 00-59 minutes)
n=0 This indicates the System Disable Timer. This setting disables all outgoing
calls while this countdown timer is non-zero.
n=1-9 This indicates telephone number n Disable Timer. This disables the dialer
from placing calls to phone number n while this countdown timer is non-
zero.
Examples- Command: 0**200000105*
Response: The system disable timer is one hour five minutes.
Command: 0**201010105*
Response: Telephone number one disable timer is one day one
hour five minutes.
The Following is an example of use:
The on-call person is going out of town for 3 days. He wishes his family not to be
disturbed while he is gone. The dialer is instructed to skip his phone number during
an alarm call-out sequence. In this case, the command 0**201030405* would
prohibit alarm calls to be placed to phone 1 for 3 days, 4 hours, and 5 minutes
beginning at the time the command is sent.
z Initializing Configuration Data These programming commands configure the
dialer with default data. Before initializing, print or FAX a copy of your dialer’s
current configuration as described in Chapter 3, Operations section.
0**09001973* Initialize System Data
0**09102846* Initialize Telephone Data
0**09200534* Initialize Channel Data
0**09310872* Initialize Runtime Data
CAUTION: Programmed data will be reset to Defaults. These commands should
only be used if it is necessary to clear out all configuration data.