System information

MICROTEL Series 1000EX Dialer

7. Configure Channel Type

z Enter the command **cc20n*, where cc is the I/O channel and n is the I/O type to

be programmed

n Setting Meaning

0 SPARE No Type Selected

1 Digital Input Normally Open Contact closure Normally Open

2 Digital Input Normally Closed Contact closure Normally Closed

3 Digital Output Digital Output that is user definable to

be Open or Closed

4 Analog Output (00.0 - 99.9%) Analog Output that is user definable to

be at some setting

5 Analog Input (00.0 - 99.9%) Current Percentage of an input value

6 Local Alarm Output Digital Output that Closes when there

is a local alarm

8 Follow Channel Output Digital Output that Closes depending

on the followed channel’s state

(see below)

NOTE: This command defaults all the information for a channel. Make sure this is the

first command performed on a channel.

8. Review Channel Input/Output Values

z Once a channel’s type has been configured (see 7 above), this channel can now

report its current status condition. Enter the command *cc0* to review the

programmed channels status conditions, where cc is the channel number 1 to 41.

This is an easy way to tell that the dialer is connected properly to the external

devices. Example: Enter *010* to review channel 1’s current status condition.

9. Assign Telephone Numbers to Individual Channels.

z Enter **cc4tt*, where cc is the I/O channel and tt is the index number of the

telephone number you wish to dial (t = 1,2,3,…32). Example: If you want an

alarm on channel 1 to call the telephone numbers 2 and 4 to report the error, enter

the command **0140204*. This will set this channel’s calling list to be the

numbers 02 and 04.

10. Configure the Inputs to Call On Alarm.

NOTE: The pre-configured inputs come from the factory disabled preventing nuisance

telephone calls.

z Enter the command, **cc82*, where cc is the input channel number on the Dialer.

Example: Enter **0382* to arm input channel number 3 to call on alarm.

z The Dialer will respond, “Channel zero three alarm setup is two, call on alarm.”