OPERATIONS MANUAL Wireless Ethernet Systems

WEB PAGES (cont’d)
E. BASIC - WIRELESS
The wireless page is used for enabling Super mode. The Super mode combines adjacent
channels to provide up to 50+ Mbps of throughput. The channels available in Super mode are: 4
and 6 only. If another channel is selected, Super mode will not be enabled. To enable Super
mode, click the arrow in the drop
down box and select “Super A
without Turbo” (30+ Mbps) or
“Super A with Static Turbo” (50+
Mbps). Each Host/Client in your
system will need to have this feature
enabled independently.
To change frequencies from the
firmware (must start with
remote side first):
1. Click on pull down menu
next to “Channel Switch
Override”
2. Select desired frequency
3. Click “Save” and follow
reboot process
4. Click on “Status” New
Frequency Selection is
shown next to “Rotary
Switch Position.” Page may
need to be refreshed to see
this configuration. Current frequency will match on the Client information page if the Host AP
is connected.
Encryption Method Default:
WPA is the highest grade of encryption available in this system and is enabled at the factory as the
default. WPA2, AES and password are the default selections. After updating the settings as desired,
click save to update the WEM. Please note that paired or grouped WEMs must have the same settings
to operate correctly.
- 14 -